Quiet Darkroom

· Chemistry · FP4 Plus · 2 min read

Caffenol on a Sunday: developing film with instant coffee

Instant coffee, washing soda and vitamin C. It smells terrible and it works. My recipe, my times and a fair comparison with a proper developer.

Coffee, a coaster and a film camera on the table.
Coffee, a coaster and a film camera on the table.

Every film forum has a thread about developing with coffee, and every thread has someone who swears by it and someone who thinks it is a gimmick. On a quiet Sunday in March I finally tried it, with a roll of FP4 that I had exposed twice over the same courtyard: half the roll for coffee, half for my usual D-76.

Why it works at all

Instant coffee contains caffeic acid and related compounds that act as developing agents once the solution is alkaline enough. Washing soda supplies the alkalinity. Vitamin C is a developing agent of its own and makes the whole mix far more active. Without it, coffee alone develops very slowly and leaves heavy stain.

A 35mm film canister next to a lens.
A 35mm film canister next to a lens.

My recipe, for 500 ml

IngredientAmount
Water at 20 °C500 ml
Washing soda crystals27 g
Vitamin C powder (pure ascorbic acid)8 g
The cheapest instant coffee in the shop20 g

The order matters. Dissolve the washing soda first, then the vitamin C, which fizzes, then the coffee. Let it stand for ten minutes so the bubbles settle. It looks like very strong coffee and smells like burnt coffee mixed with a swimming pool.

Development

Fifteen minutes at 20 °C, with gentle inversions for the first minute and then three inversions every minute. Stop with water, fix as usual. The wash needs to be longer than usual; I give it fifteen minutes because the coffee leaves a brown tint in the tank.

Film development in a photo department darkroom, early twentieth century.
Film development in a photo department darkroom, early twentieth century.

How it compares

Cut in half, the two strips sat side by side on the light box. The coffee half was a little thinner in the shadows and had a faint brown stain across the whole strip, including the film base. Grain was slightly more visible but not dramatically. Sharpness looked the same to me. Scanned and inverted, the stain disappears; printed on multigrade paper, it acts like a very slight extra filter and lowers contrast a touch.

A house on a quiet street corner.
A house on a quiet street corner.

Will I switch? No. A bottle of liquid developer is easier, more consistent and does not need weighing. But I like knowing that if I ran out of chemistry on a Sunday evening, the kitchen cupboard would get me through.

— Elin, 16 March 2025