Quiet Darkroom

· Workflow · HP5 Plus · 2 min read

Bulk loading 35mm: thirty metres of film and a daylight loader

Buying film in thirty-metre rolls and loading my own cassettes roughly halves the cost per roll. Here is how it goes, and what can go wrong.

A heap of used 35mm film cassettes.
A heap of used 35mm film cassettes.

Film prices went up again this year, and I shoot a roll or two a week. Bulk loading had been on my list for a long time. In September I finally bought a daylight bulk loader second-hand, a bag of reusable cassettes and a thirty-metre roll of HP5.

The loader

The loader is a light-tight box with a chamber for the bulk roll and a small compartment where a cassette sits on a spindle. The bulk roll only needs to go into the chamber once, in total darkness; I did it in the changing bag. After that everything is done in normal light: open the small door, attach the end of the film to the cassette spool with tape, close the door, and turn the crank. A counter on the side shows the number of exposures.

A 35mm cassette. Reusable ones for bulk loading look much plainer.
A 35mm cassette. Reusable ones for bulk loading look much plainer.

How many rolls

Thirty metres gives about eighteen rolls of thirty-six exposures, depending on how much leader you leave. I load mine to thirty-six on the counter and get thirty-seven or thirty-eight frames, which is a small bonus. Shorter loads are possible too, and I made a few rolls of twelve for test shots, which is something you cannot buy.

An empty film canister.
An empty film canister.

What can go wrong

  • Scratches. If grit gets into the felt light trap of the loader or the cassette, it will scratch every frame along the whole length. I clean the felt with tape before each session and throw away cassettes after five or six uses.
  • Fogged ends. The first and last few frames of a bulk-loaded roll are sometimes fogged, because a little light gets in while attaching the film. I accept losing a frame at each end.
  • Labels. Home-loaded cassettes all look the same. I write the film and the date on a strip of tape on each one, every time, before it leaves the loader.

The numbers

Without being too exact, the cost per roll came out at a little more than half the price of a factory roll. The loader paid for itself on the first thirty metres. More useful than the saving is the freedom: I no longer feel bad about a whole roll spent on a single subject or a quick test.

A cassette with the leader pulled out, ready for the camera.
A cassette with the leader pulled out, ready for the camera.

— Elin, 28 September 2025